Hi Zybnek,
I have a similar issue whereby when I am monitoring the ampage in WhatsUpGold it only reports that its 16 amps rather than 1.6 amps which it actually is as displayed by the PDU device when you plug in directly to the PDU's Gui. So I thought it might be an issue with the MIB file specifically PowerNet MIB which i imported and i then changed the PDU load variables from intergers to strings as i thought the original value of 1.6 was being converted to a non floating point type bringing it back to 16 but this hasnt sorted the issue.
The OID is the same as above
I would appreciate any assistance you can give, thanks
Colin